Strike back type crusher rotor is mixed strike back the adjustment of scaleboard clearance problem

  • Strike back type crusher rotor is mixed strike back the adjustment of scaleboard clearance problem

    Crusher website: Strike back type crusher rotor is mixed strike back the adjustment of scaleboard clearance
    SBM expert understands, when striking back the rotor of type crusher is moving, rotor and strike back the clearance between scaleboard cannot be adjusted.

    If stock is agglomerate,stop striking back board with board carapace between, the proposal is raised a little before readjust clearance strike back frame, so agglomerate into makings can become loose, strike back frame adjust easily, if strike back,wear not quite enough, can dab on relaxation pull rod (protect with a board) .

    Rotor and the clearance that turn over scaleboard are finished by the adjusting gear of the machine, loosen screw is covered above all, grow nut in roll next, right now, pull rod can move along arrowhead direction, had adjusted cover screw again screw. (attention: Be sure to screw) .
    Change fragile when, after be being opened above all, go up frame. When using, first will hind go up frame with in the join bolt debus of casing, twist the 6 horn head that uses renovate device to divide with spanner next, will hind on frame open slowly, here at the same time, after the cable suspension that can use frame upper part as string of 1, wear. Repeat afore-mentioned processes, after closing namely, go up frame.